DISPLAY CASE ASSEMBLY INSTRUCTIONS

Assembly graphic showing how to remove the protective coating from the acrylic parts

Step 1

Remove Protective Coating

All pieces include a protective paper coating to prevent damage during shipping. Be sure to remove this coating from all pieces before assembling the display cases.

Assembly graphic showing how to insert the mounting studs into the acrylic

Step 2

Insert Studs

Insert the provided LEGO studs into their corresponding pieces before assembling.

Note: If the studs do not fit in their holes, turn the piece over and insert them into the other side. The stud holes have a slight angle to ensure a proper fit.

assembly graphic showing how to snap together the display case

Step 3

Assemble Display Case

All pieces are pressure-fitted and do not require glue. The front and rear pieces include small connector pins that should face upward.

Pro Tip: The cases have a strong fit. Opening the case after assembly can be difficult, but the connector pins on top of the case can be used as leverage to make it easier.